2005 Chrysler SEBRING Recalls
Learn What to Do if Your SEBRING Has Been Recalled
The following recalls have been announced by Chrysler, so if you own a 2005 SEBRING take action immediately to get your automobile fixed. Interested in how this information is collected? Read more about recalls and the NHTSA.
- Call Chrysler to get more information. Verify that the cost of repairs will be covered free of charge
- Setup an appointment with a local authorized mechanic to schedule your maintenance
- Keep up to date with recalls for your vehicle by following this page
Recent 2005 SEBRING Recalls
-
SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT Recall for 2005 CHRYSLER SEBRING
Summary: Qualis automotive is recalling certain aftermarket ball joints sold for use on certain passenger vehicles. The socket may have been excessively hardened which could cause it to crack near the retaining ring groove allowing the ball stud to separate under impact load. The subject ball joints were sold as four part numbers, D10945, D10946, G10945, and G10946. The affected control arms, D10945 and D10946, are stamped with the following dates on the ball joints: 134308, 135708, 100109, 102709, 104109, 105509, 107609, 108909, 110309, 113209, and 116609. The G10945 and G10946 are the same part as the D10945 and D10946 respectively. They are labeled differently depending on the aftermarket customer.
Consequence: Separation of the ball stud from the socket of the ball joint housing would allow the control arm to collapse and the wheel to fold in causing loss of steering control, possibly resulting in a crash.
Fix: Qualis automotive will replace the ball joints free of charge. The safety recall began on November 9, 2009.
For detailed information & supporting documents, see the official NHTSA page concerning recall #09E056000 »
-
EXTERIOR LIGHTING Recall for 2005 CHRYSLER SEBRING
Summary: Sabersport is recalling 16,270 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of Federal Motor Vehicle Safety Standard no. 108, "Lamps, Reflective Devices, And Associated Equipment." These lamps do not contain the required amber side reflectors.
Consequence: Decreased lighting visibility may result in a vehicle crash.
Fix: Sabersport will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on May 11, 2009. Owners may contact sabersport at 1-909-598-7589.
For detailed information & supporting documents, see the official NHTSA page concerning recall #09E012000 »
-
SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER Recall for 2005 CHRYSLER SEBRING
Summary: Certain cardone master cylinders with date codes lower than dca7078 sold as replacement equipment for use on the vehicles listed above. The seal on master cylinder can fail and leak brake fluid.
Consequence: Loss of brake fluid can result in poor braking performance, possibly resulting in a vehicle crash.
Fix: Cardone will notify owners and offer to repurchase any defective master cylinders. The recall began during April 2007. Owners can contact cardone at 1-800-777-4780.
For detailed information & supporting documents, see the official NHTSA page concerning recall #07E023000 »
-
STEERING:LINKAGES:KNUCKLE:SPINDLE:ARM Recall for 2005 CHRYSLER SEBRING
Summary: On certain sedans and convertible model vehicles, the right steering knuckle may have been damaged during the component manufacturing process.
Consequence: This could cause the steering knuckle to crack and separate from the upper control arm, which could result in a crash.
Fix: Dealers will inspect and replace the right steering knuckle. The recall began on December 27, 2004. Owners should contact DaimlerChrysler at 1-800-853-1403.
For detailed information & supporting documents, see the official NHTSA page concerning recall #04V579000 »
-
SEAT BELTS:REAR Recall for 2005 CHRYSLER SEBRING
Summary: On certain sedans, the left and right rear outboard retractor and turning loop bolts on the seat belts may not have been properly tightened.
Consequence: In the event of a crash, the seat occupant may not be properly restrained, increasing the risk of injury.
Fix: Dealers will inspect and tighten the affected fasteners. The recall began on November 15, 2004. Owners should contact DaimlerChrysler at 1-800-853-1403.
For detailed information & supporting documents, see the official NHTSA page concerning recall #04V532000 »